Cross Cylindrical Roller Bearing Installation Method and Precautions

Crossed cylindrical roller bearing is a common rolling bearing, which is widely used in all walks of life. Crossed roller bearing is also a consumable, because incorrect installation or operation will affect its service life, and in serious cases, it will lead to bearing failure. If it is damaged, the bearing has to be replaced in time to make the equipment run normally. Below, the manufacturer of the crossed cylindrical roller bearing will introduce the correct installation method and precautions of the crossed cylindrical roller bearing!

Installation steps of crossed cylindrical roller bearings

Crossed cylindrical roller bearing

1. Check before installation

Thoroughly clean the spindle, bearing housing or other mounting parts, remove oil or impurities, and check for burrs or burrs. After confirmation, the spindle, housing and components are ready to start installation.

2. Install the bearing

When the crossed cylindrical roller bearing is installed in the shaft or the bearing housing, because it is a thin-walled bearing, it is easy to tilt during installation. In order to prevent this phenomenon, it is necessary to use a plastic hammer evenly while keeping it level, and carefully install the crossed cylindrical roller bearing into the bearing housing or the shaft little by little until it is confirmed by sound that it is completely abutted with the reference surface. until.

Details can be accessed by clicking here: